|Charge current||20 A|
|Charger AC Input||187-265 VAC Input frequency: 45 – 65 Hz|
|Cont. output power at 25°C (W)||430 W|
|Input voltage range (V DC)||9,5 – 17V|
|Max efficiency (%)||90|
|Output AC voltage/frequency||230VAC ± 2% 50Hz ± 0,1%|
|Peak Power (W)||900 W|
|Protection||- output short circuit - overload - battery voltage too high - battery voltage too low - temperature too high - 230 V AC on inverter output - input voltage ripple too high|
|Transfer switch (A)||16|
|Zero load power (W)||6|
The full bridge plus toroidal transformer topology has proven its reliability over many years. The inverter is short circuit proof and protected against overheating, whether due to overload or high ambient temperature.
High start-up power
Needed to start high inrush loads such as power converters for LED lamps, halogen lamps or electric tools.
When Search Mode is ‘on’, the power consumption of the inverter in no-load operation is decreased by approx. 70%. In this mode the Multi, when operating in inverter mode, is switched off in case of no load or very low load, and switches on every two seconds for a short period. If the output current exceeds a set level, the inverter will continue to operate. If not, the inverter will shut down again.
By default, the programmable relay is set as an alarm relay, i.e. the relay will de-energise in the event of an alarm or a pre-alarm (inverter almost too hot, ripple on the input almost too high, battery voltage almost too low).
Remote on / off / charger on
Remote operation can be implemented by connecting a switch to the three pole connector